Professional hvac installation services for homes and businesses in Oklahoma City and surrounding Oklahoma communities.
A complete HVAC installation from KIC Refrigeration in Oklahoma City, OK addresses every element in the comfort chain, from the air handler and condensing unit to the thermostat, ductwork, and filtration system. We ensure proper airflow balance, verified refrigerant charge, tested safety controls, and code-compliant operation before turning the system over to you.
Properties throughout Oklahoma City (pop. 727,836) face unique demands when it comes to hvac installation. Oklahoma heating loads, cooling calculations, and the insulation levels and duct configurations found in Oklahoma City homes all influence the approach we take. KIC Refrigeration tailors every hvac installation project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for hvac installation in Oklahoma City, OK makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
From initial contact to final verification — here is how we handle hvac installation.
Our Oklahoma City estimator walks your property room by room — measuring square footage, checking insulation levels, assessing window area, and inspecting existing ductwork and electrical service. We input all variables into a Manual J load calculation to determine your exact heating and cooling requirements in BTU.
Based on load calculations and your priorities — efficiency, noise level, budget, zoning — we recommend specific equipment and provide a detailed written proposal covering equipment model numbers, SEER2/AFUE ratings, installation scope, warranty, and total cost.
KIC Refrigeration installs HVAC systems in Oklahoma City, OK to the highest standards. We set equipment on level, vibration-isolated mounting, braze all refrigerant connections with nitrogen flowing, pressure test with dry nitrogen, evacuate to below 500 microns, charge by weight, seal all duct connections with mastic, and verify gas piping sizing and connections.
Our Oklahoma City technician commissions the system by verifying superheat, subcooling, temperature split, static pressure, and gas pressure in heating mode. We program the thermostat, register your manufacturer warranty, label the electrical panel, and walk you through operation and maintenance.
Transparent answers about hvac installation from our certified technicians.
Complete HVAC installation in Oklahoma City ranges from $7,000 to $15,000 for a mid-efficiency furnace and AC combination — typically an 80 percent AFUE furnace paired with a 14.3 to 16 SEER2 condenser. High-efficiency systems with variable-speed blowers and two-stage or variable-speed compressors run $12,000 to $22,000 but deliver significantly lower operating costs and qualify for federal tax credits. Heat pump systems fall between $5,000 and $18,000 depending on whether the system is single-stage, variable-speed, or a dual-fuel configuration. Ductwork modifications or new duct runs add $1,000 to $5,000. KIC Refrigeration provides detailed written proposals for Oklahoma City homeowners with every cost itemized and no hidden fees.
Yes. KIC Refrigeration pulls all required mechanical, electrical, and gas permits for every HVAC installation in Oklahoma City, OK. We prepare the permit application with equipment specifications and installation plans, pay the permit fee, schedule the inspection with the local building department, meet the inspector on-site, and ensure the installation passes all applicable mechanical code requirements. A building permit is not optional — it is required by law in most Oklahoma City jurisdictions, and an unpermitted installation can void the manufacturer equipment warranty, create title problems when selling the home, and may not be covered by homeowner insurance if an HVAC failure causes property damage. KIC Refrigeration includes permitting in every installation project.
Yes, substantially. Replacing a 10 SEER air conditioner with a 16 SEER2 unit reduces cooling energy consumption by approximately 38 percent. Upgrading from an 80 AFUE furnace to a 96 AFUE condensing furnace saves 16 cents of every heating dollar — the old furnace sends 20 cents up the flue while the new one captures it. Combined with proper installation practices — correct refrigerant charge verified by superheat and subcooling, proper static pressure and airflow at 400 CFM per ton, sealed duct connections, and a programmable thermostat — a new system typically saves Oklahoma City homeowners $600 to $1,800 per year depending on home size, usage patterns, and local energy rates.
KIC Refrigeration works with homeowners in Oklahoma City to make HVAC installation affordable through flexible payment options. We provide information on financing programs that can spread the cost over 36 to 120 months with approved credit, making a $12,000 system as manageable as $100 to $200 per month. Some programs offer promotional periods with reduced interest rates for the first 12 to 24 months. We also help Oklahoma City homeowners identify and apply for utility rebates, manufacturer rebates, and the federal energy tax credit of up to $2,000 that can reduce the net project cost significantly. Ask about current financing options during your free in-home estimate.
Our reputation is built on certified technicians, honest pricing, and results that last.
"These guys are the real deal. Boiler was making a terrible noise and they diagnosed the problem in minutes. Runs perfectly now."
"KIC Refrigeration installed a new furnace for us last winter. The team was respectful of our home, wore boot covers, and cleaned up everything. Top notch."
"Our dryer was taking forever to dry clothes. Turned out the vent was almost completely clogged. Quick cleaning and now it works like new again."